I've run into a problem with bash, which I have traced to the
current_job not being set by the time a process is terminated with a ^C
To reproduce:
1. make sure there are no other running bash jobs
2. make sure shopt -s checkwinsize is enabled
3. run a long running process, like "find /"
4. resize the window during the process (making the window slightly
bigger is normally best).
5. kill the process with ^C
6. notice that bash has not noticed the resize. (an easy way to do
this is to make sure that there are things in your history which had to
wrap... or if the command prompt itself had to wrap).
If you were to instead first ^Z the process, and then fg, and ^C it
*WOULD* notice the resize. Also, if the process terminates normally,
it notices the resize (with checkwinsize set).
This error is caused by the following code in jobs.c not getting
executed:
if (WIFSIGNALED (s) || WIFSTOPPED (s))
{
set_tty_state ();
/* If the current job was stopped or killed by a signal,
and
the user has requested it, get a possibly new window
size */
if (check_window_size && job == current_job) //
CURRENT_JOB IS = NO_JOB
get_new_window_size (0); // THIS IS NOT GETTING
EXECUTED.
you will see that current_job is equal to -1 (NO_JOB) when this is
reached, even though the job of the only running process is 0.
Unfortunately, I don't know enough about bash to determine where
current_job should be getting set... So my current *hack* for Apple's
version of bash is to remove the check job == current_job. This will
cause a little more network traffic in some cases but shouldn't be too
much of a problem.
If someone more knowledgeable could fix the *real* problem of
current_job not being set, and send me a patch I would be very
grateful.
btw, this is with
GNU bash, version 2.05b.0(1)-release (powerpc-apple-darwin7.0)
Thank you for your time and support.
Sincerely,
Eric Seidel
----------------------------
Eric Seidel
eseidel@apple.com
BSD Technologies
Apple Computer